You are here: Home » NEWS »

What is the Difference Between Aluminum Composite Panel and Aluminum Gusset?

As an Aluminum Composite Panel supplier, share with you. Aluminum buckle plate: it is a ceiling material made of aluminum alloy plate, which is generally aluminum-magnesium alloy; from the shape, it can be divided into two types: square plate and strip plate. The peritoneal plate and the roll-coated plate, among which, the peritoneal plate is suitable for home use due to its high cost performance, ease of cleaning and resistance to discoloration.

Aluminum Composite  Panel

Aluminum-plastic plate: A thin aluminum plate is applied on the surface of the plastic. The aluminum plate indicates that most of the treatment process uses roll coating. The price varies according to the thickness of the aluminum plate. Generally speaking, the aluminum-plastic plate over 12s is more suitable for home improvement Use, too thin will affect the service life. Aluminum-plastic panels can be used for kitchen and bathroom ceilings.

What aspects need to pay attention to in the use of Aluminum Composite Panel:

1. Aluminum-plastic board should be stored or installed in a dry and ventilated place to avoid water accumulation, and the ambient temperature is not higher than 70 ℃. Avoid installation in harsh environments such as soot, wind and sand, radiation, harmful gases and chemical environments.

2. The aluminum-plastic plate should be laid flat during transportation or storage. During the transportation process, lift the board 4 sides at the same time, do not drag on one side, so as not to scratch the board surface.

3. When grooving, you should use a round head or a V-shaped flat saw blade or milling cutter ≥90 degrees to grooving, and you need to leave a 0.2-0.3mm thick plastic core board along with the panel to increase the strength and toughness Aluminum sheet hydrogenation. Excessively sharp corners or cutting damage to the aluminum panel or the remaining plastic is too thick can cause the aluminum plate to break or the paint film to burst when bending.

4. Use even force when bending, do not bend repeatedly, otherwise the aluminum panel will break.

5. In order to maintain the flatness of the aluminum-plastic plate and enhance its wind resistance, the aluminum-plastic plate needs to be lined with a skeleton after being bent and glued to the plate.

6. Do not use it in one step when decorating the curved surface. The bending radius should be greater than 30cm. Use the bending equipment to bend the aluminum-plastic panel and slowly apply force to make the panel gradually reach the required curved surface.

7. In order to avoid visual disparity, the aluminum-plastic board should be installed on the same side in the same flow direction.

8. After installation, the protective film should be removed within 45 days to avoid aging of the protective film. When tearing the film, it may cause adhesive residue.

9. The inner wall panel should not be installed outdoors to ensure its service life.

10. If the surface of the board is contaminated during construction or use, it can be cleaned with a neutral detergent. Avoid cleaning with strong acid or alkaline detergent, which will damage the board surface.

Our company also has Splashback Aluminum Composite Panel for sale, please contact us.